diff --git a/board/zynqmp/readme.txt b/board/zynqmp/readme.txt
index a98ff78f6f..242c643480 100644
--- a/board/zynqmp/readme.txt
+++ b/board/zynqmp/readme.txt
@@ -86,25 +86,19 @@ updated for any programmable logic or DDR customizations which impact
 psu_init (clock/pin setup & mapping/AXI bridge setup/etc). See
 board/xilinx/zynqmp/ directory of U-Boot for natively supported psu_init
 files. If the psu_init files for your board are not found in U-Boot,
-you need to add them by yourself.
+you need to add them using BR2_TARGET_UBOOT_ZYNQMP_PSU_INIT_FILE.
 
 1) Start with a defconfig supported by Buildroot (e.g. ZCU106)
     make zynqmp_zcu106_defconfig
 
-2) make uboot-menuconfig
-    Visit the following menu and enable CONFIG_XILINX_PS_INIT_FILE
+2) make menuconfig
+    Visit the following menu to configure BR2_TARGET_UBOOT_ZYNQMP_PSU_INIT_FILE
 
-    ARM architecture  --->
-       [*] Zynq/ZynqMP PS init file(s) location
+    Bootloaders  --->
+       U-Boot  --->
+          (<Path to psu_init_gpl.c>) Custom psu_init_gpl file
 
-3) Copy psu_init_gpl.c/h generated by the Xilinx Vivado tools into
-   output/build/uboot-custom/board/xilinx/zynqmp/custom_hw_platform/
-
-4) make
-
-Note: The files in step 3 will need to be re-copied after cleaning the
-output directory and at this time, there is no way to save them as
-part of the buildroot configuration, except as a U-Boot patch.
+3) make
 
 ==============
 Important Note